I just did a REFRESH of my Acer ATC-105-UR10
After it came back to life I went looking the system to see if it set up correctly and I found this under Protection Settings when you go to Configure System Restore.
After Speaking to ACER’s technicial support. I changed the settings for the SYSTEM Protection back to the way it was after the hard drive was REFRESHED.
AFTER I Did the Refresh. I actually set PUSH BUTTON RESET to “ON”, since I thought it should be ON and protecting!
After the Reset of the PC when I Went to Recovery and looked at
CONFIGURE SYSTEM RESTORE it was set like this:
Available Drives Protection
Acer (C) (System) ON
Push Button Reset OFF
I then changed “Push Button Reset” to “ON”.
I thought I better call Acer, and 2 technicians, one a supervisor, told me to set “Push Button Reset” to OFF again, since that is the way the technicians set this up in order to not damage the hard drive.
Since when it was Refreshed it was OFF, they said LEAVE IT AS YOU FOUND IT!
I HOPE THIS IS CORRECT!!
Here is how it looks NOW: (IS THIS CORRECT??? What is PUSH BUTTON RESET for anyway???)
Will my PC still create restore points? Is this correct? Acer said leave it this way!